Bogen CM-810 Provozní pokyny Strana 29

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 78
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 28
Installation and Connection
GMS810-/GMS811-FIDOR · Operating Instructions · 8013911 V1-0 · © SICK AG 29
Subject to change without notice
3.7 CAN bus
FIDOR can be connected with a CAN bus to SICK devices (SCU, BCU, I/O modules).
If no device is connected to the CAN bus socket of the FIDOR: Connect the attached termi-
nating resistor to the CAN bus socket.
3.8 Ethernet interface
Procedure
Connect the Ethernet
Socket on the FIDOR: RJ45.
3.9 Connecting the power supply
1 Compare the supplied mains voltage with the information on the type plate.
If the voltages do not match: Please contact SICK Customer Service.
2 Connect the power supply.
The remote control used is set at the factory depending on the order.
To exchange the remote control: Please contact SICK Customer Service.
More information Technical Information “FIDOR”.
The risk of undesired access (“hackers”) to the FIDOR is inherent when operat-
ing the FIDOR via Ethernet.
Only operate the FIDOR with firewall protection.
CAUTION: Hazards caused by electric voltages
Only let the work described in the following be carried out by skilled electri-
cians who are familiar with potential risks and are able to avoid them.
NOTICE:
Before signal connections are established (also with plug connections):
Disconnect the FIDOR and all connected devices from the mains (switch
off).
Otherwise the internal electronics can be damaged.
Zobrazit stránku 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 77 78

Komentáře k této Příručce

Žádné komentáře